Display Assembly - HP 15-cx0000 Maintenance And Service Manual

Display assembly

You can remove the display bezel, display panel, and camera module without removing the display assembly
from the computer. For more information, see
must remove the display assembly to remove the remaining subcomponents, as described in this section.
Display subcomponent spare parts are listed at
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
7. Remove the fan assembly (see
8. Remove the system board (see
To remove the display assembly:
1. Remove the four black Phillips M2.0×5.0 screws (1) and four broad head Phillips M2.0×2.0 screws (2)
that secure the display assembly to the computer.
2. Lift the display to bend the hinges upward (3).
3. Separate the display from the computer (4).
If it is necessary to replace display assembly subcomponents:
1. Remove the display bezel and display panel (see
on page
64 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page
Hard drive on page
Fans on page
System board on page
29).
Display subcomponents (bezel, panel, camera) on page
Display assembly subcomponents on page
36).
39).
47).
50).
60).
Display subcomponents (bezel, panel, camera)
29.You
19.