Card Reader Board - HP 15-cx0000 Maintenance And Service Manual

Card reader board

Description
Card reader board for use only in models with GeForce GTX 1060 Max-Q graphics
Card reader board for use all models without GeForce GTX 1060 Max-Q graphics
Card reader board cable
Before removing the card reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
To remove the card reader board:
1. Disconnect the cable from the ZIF connector on the card reader board (1).
2. Remove the tape from the board (2).
3. Remove the two Phillips M2.0×2.0 screws (3) that secure the board to the computer.
4. Lift the rear of the board up, and then pull it away from the side of the computer to remove it (4).
Reverse this procedure to install the card reader board.
Bottom cover on page
Battery on page 39).
Hard drive on page 47).
36).
Component replacement procedures
Spare part number
L20329-001
L25944-001
L20330-001
49