Id Status; Server Communication Status; Ip Status; Zigbee Status - SolarEdge StorEdge Installation Manual

ID Status

This screen displays the inverter software version and the country to which the inverter is configured.
I D : # # # # # # # #
D S P 1 / 2 : 1 . 0 2 1 0 / 1 . 0 0 3 4
C P U : 0 0 0 3 . 1 4 x x
C o u n t r y : U S A 1
ID: The inverter ID.
l
DSP 1/2: The DSP digital control board firmware version
l
CPU: The communication board firmware version
l
Country: the current country setting
l

Server Communication Status

S e r v e r : L A N
S t a t u s :
x x x x x x x x
< E R R O R
NOTE
If the connection method is CDMA (Cellular) or GSM, the server screen is replaced with the Cellular
or GSM status screens (see Cellular Status on the next page and GSM Status on the next page).
Server: The method of connection to the SolarEdge monitoring portal.
l
S_OK: The connection to the SolarEdge monitoring portal is successful (should appear only if the
l
inverter is connected to the server).
Status: Displays OK if the inverter established successful connection and communication with the
l
specified server port/device (LAN, RS485 or ZigBee module).
xxxxxxxx: Eight-bit Ethernet communication connection status: A string of 1s and 0s is displayed. 1
l
indicates OK, 0 indicates an error. F or a list of the possible errors and how to troubleshoot them, refer
to Communication T roubleshooting on page 79.
Error message, according to failure. Refer to Errors and Troubleshooting on page 1.
l

IP Status

This screen describes the Ethernet configuration: IP, Mask, Gateway and MAC address (Media Access
Control) of the Inverter.
I P 1 9 2 . 1 6 8 . 2 . 1 1 9
M S K 2 5 5 . 2 5 5 . 2 5 5 . 0
G W 1 9 2 . 1 6 8 . 2 . 1
M A C 0 - 2 7 - 0 2 - 0 0 - 3 9 - 3 6

ZigBee Status

This screen describes the ZigBee configuration:
P A N : X X X X X
C H : X X / X X X X
M I D : X X X X
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.0
# #
< S _ O K >
< O K >
M E S S A G E >
R S S I : < L >
X X
Chapter 7: User Interface
51