Chapter 7: User Interface; Lcd User Buttons; Removing The Inverter Cover - SolarEdge StorEdge Installation Manual

Chapter 7: User Interface

LCD User Buttons

Four buttons are located inside the inverter above the LCD panel and are used for controlling the LCD
menus, as shown below:
Use the four user buttons to control the LCD panel menus:
Esc: Moves the cursor (>) to the beginning of the currently displayed parameter; goes to the previous
l
menu, and cancels a value change with a long press (until Aborted is displayed).
Up (1) and Down (2): Moves the cursor from one menu option to another, moves among the
l
characters of a displayed parameter, and toggles between possible characters when setting a value.
(3): Selects a menu option and accepts a value change with a long press (until Applied is displayed).
l
Use the three rightmost buttons for entering 123 when entering the Setup mode password 12312312.
The LCD screen displays status information of the system and various menus for configuration options.
The LCD panel and buttons are used during the following processes:
Operational mode: The LCD panel allows checking for proper system o peration. Refer to Status
l
Screens - Operational Mode on page 49 for a description of this option. Use the LCD light button to
toggle through the informative displays.
Setup mode: Upon installation, the installer may perform basic configuration
l
Error messages: In the event of a problem, an error message may be displayed on the LCD panel.
l

Removing the Inverter Cover

Use the following procedure for cover removal for communication connection or maintenance.
1. Turn OFF, or verify that the StorEdge Connection Unit is OFF.
2. Turn OFF, or verify that the inverter ON/OFF switch is OFF.
3. Verify that AC to the inverter is OFF, or disconnect the AC to the inverter by turning OFF the circuit
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.0
Figure 26: LCD Internal menu buttons
Chapter 7: User Interface
39