Align the two indentations in the inverter enclosure with the two triangular mounting tabs of the
l
bracket, and lower the inverter until it rests on the bracket evenly.
5. Secure the StorEdge Connection Unit bracket to the wall:
Mark the location of the bracket screw for the Safety SwitchStorEdge Connection Unit and drill the
l
hole.
Fasten the bracket using a standard bolt.
l
Verify that the bracket is firmly attached to the mounting surface.
l
6. Insert the two supplied screws through the outer heat sink fin on both sides of the inverter and into
the bracket (see Figure 12). Tighten the screws with a torque of 4.0 N*m / 2.9 lb.*ft.
7. Remove the inverter cover: Open the inverter cover's six Allen screws and carefully pull the cover
horizontally before lowering it.
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.0
Figure 12: Hanging the inverter on the bracket
Figure 13: StorEdge Connection Unit bracket
Chapter 3: Installing the Inverter
23