Adjusting Handlebar Height; Brake Operation - Drive R8 Assembly & Operating Instructions

Adjusting Handlebar Height

To adjust the height of the
handlebars, unscrew the tightening
handles on either side of the Rollator
turning anti-clockwise and remove.
Adjust the height of the handlebars to
suit the user, re-insert the tightening
handles and tighten by turning
clockwise to secure (as shown in the
picture).
Ensure that the tightening handles
and brake cables are on the outside
of the Rollator.
7
Unscrew
Tighten

Brake Operation

To operate the brakes:
Squeeze the brake levers up and hold
in position to engage the brakes
(as shown by the green arrow).
Release the levers to release the
brakes.
To lock the brakes:
Push down on the brake lever until it
locks and stays in down position
(as shown by the green arrow).
Important:
Ensure that the brakes are locked on
when sitting on the seat.
To unlock the brakes:
Pull up on the brake lever until the
lock removes (as shown by the
green arrow).
Note: The brakes on Rollators are factory
set and should not require adjustment. For
technical assistance on the Rollator brakes,
contact your Drive Medical Ltd dealer.
Brakes
engaged
Brakes
locked
Brakes
unlocked
8