Siemens SIPART PS2 Operating Instructions Manual page 71

1. You have performed the steps described in the section "General information on installing
option modules (Page 51)".
2. Unplug the ribbon cable connector
⑤
3. Remove the basic electronics
that fix the basic electronics to the pneumatic block.
4. Loosen the screw
5. Insert the connector of the ribbon cable (A) into the slot as shown below.
Note: There is no space for the ribbon cable (A) in earlier versions of the positioner. Here
you fasten the ribbon cable with the supplied cable tie at the container.
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
electronics.
9. Fasten the module cover. Make sure that the ribbon cable is not trapped.
10.Proceed with the corresponding steps in the section "General information on installing
option modules (Page 51)".
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
.
⑥
in the connection area of the positioner.
⑤
④
to the fitted potentiometer from the basic electronics
⑤
from the positioner. To this end, remove the two screws
⑥
loosened in the fourth step.
back into the positioner.
④
of the EMC filter module onto the positioner basic
Installing/mounting
4.6 Installing option modules
71