Installing/mounting
4.2 Mounting the linear actuator
9. Install the mounting bracket
2 spring lock washers
Figure 4-4
Figure 4-5
10.Select the row of holes. The selection of the row of holes depends on the yoke width of the
actuator. Select the row of holes in such a way that the carrier pin
up bracket
clamping pieces
11.Keep the positioner and the fastening bracket on the actuator. Ensure that the carrier pin
④
40
⑩
and 2 flat washers
Installation with mounting bracket
Installation with mounting bracket, flameproof enclosure
②
near the spindle. Ensure that the pick-up bracket
③
.
is guided inside the pick-up bracket
①
at the rear side of the positioner. Use 2 hexagon bolts
⑪
for this purpose.
②
.
Operating Instructions, 05/2017, A5E00074631-AC
④
meshes with the pick-
②
does not touch the
SIPART PS2 with and without HART
⑨
,