Siemens SIPART PS2 Operating Instructions Manual page 38

Installing/mounting
4.2 Mounting the linear actuator
1. Install the clamping pieces
socket cap screws
2. Slide the pick-up bracket
Figure 4-1
3. Set the necessary length.
4. Tighten the screws
5. Fix the pre-installed carrier pin
⑭
Figure 4-2
6. Set the stroke value. Use the stroke value specified on the nameplate of the actuator for
this purpose. If none of the values on the lever scale matches the stroke value of the
actuator, select the next higher value on the scale. Position the pin center
corresponding value of the scale. If you need the value of actuator travel after initialization
in mm: ensure that the configured stroke value matches the value of the "3.YWAY"
parameter.
38
⑰
for this purpose.
②
Pick-up bracket
⑰
so that you can still shift the pick-up bracket
⑱
and hexagon nut for this purpose.
Lever with carrier pin
③
on the actuator spindle. Use spring lock washers
into the milled recesses of the clamping pieces
④ ⑥
to the lever . Use the flat washer
Operating Instructions, 05/2017, A5E00074631-AC
⑯
and
③
.
②
.
⑫
, spring lock washer
④
on the
SIPART PS2 with and without HART