Technical Specifications 19" Slide-In Module 4 To 20 Ma - Siemens SIPART PS2 Operating Instructions Manual

Positioner with remote control electronics
F.2 19" slide-in module
5. Connect the wires of the cable
connector
6. Connect the positioner 6DR5910
slide-in module
7. Connect the wires of the cable
according to the following table:
8. Connect the 19" slide-in module
system
F.2.3

Technical specifications 19" slide-in module 4 to 20 mA

You can find the valid technical specifications for the positioner Technical data (Page 231).
The technical specifications valid for the 19" slide-in module 4 to 20 mA are set out below.
Rated conditions
Degree of protection
● Front
● Back page
Mounting position
Vibration resistance
● Harmonic oscillations (sine wave) according to
DIN EN 60082-2-6/05.96
● Oscillations (sinusoidal) according to
DIN EN 60068-2-6/04.96
● Shock (half-sine) according to DIN EN 60068-2-27/02.2010 150 m/s² (492 ft/s²), 11 ms, 6 shocks/axle
298
①
according to the following table:
Connecting Assignment
terminals
④ ⑤
/
2 GND
3 Vref
4 Vcc
5 Vpos
⑬
.
Assignment of female connector
1 Position feedback Iw +
2 Position feedback Iw -
3 -
4 -
5 -
⑩
.
②
to the connecting terminals
Assignment, Connecting
male connector terminals
① ④
/
7 6
6 7
- 8
5 9
10
③
using the SUB-D female connector
⑧
at the current input
⑦ ⑪
/ Assignment of female connector
6 -
7 -
8 Current input Iy +
9 Current input Iy -
⑬
via the SUB-D female connector
IP40 acc. to DIN EN 60529
IP20 acc. to DIN EN 60529
Any
3.5 mm (0.14"), 5 ... 8.4 Hz, 4 cycles/axle
10 m/s² (33 ft/s²), 8.4 ... 500 Hz, 4 cycles/axis
KWU DD 7080.9/93
KTA 3503 from 11.86
Operating Instructions, 05/2017, A5E00074631-AC
④
and to the SUB-D male
Assignment Assignment,
male connector
⑥ ①
Not assigned -
Discharge + 2
Discharge - 1
Supply + 15
Supply - 14
⑦
⑨
and at the position feedback
⑦
with the controls
SIPART PS2 with and without HART
with the 19"
⑪
⑦ ⑨
/