Siemens SIPART PS2 Operating Instructions Manual page 297

Connecting
①
D-SUB male connector 9-pin
③
Positioner 6DR59..
⑤
Connecting terminals of potentiometer
⑦
D-SUB female connector 15-pin
⑨
Current input Iy = 4 to 20 mA
⑪
Position feedback I
⑬
Description 19" slide-in module 4 to 20 mA
Figure F-4 Connecting basic electronics to power supply
Procedure
Observe the safety instructions for connection in section Basic safety instructions (Page 73).
1. Strip 5 mm of the cable shield on the cable
2. Open the positioner 6DR5910. Unscrew the four fixing screws of the enclosure cover.
3. Insert the prepared cable
4. Tighten the cable entry.
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
= 4 to 20 mA (setpoint)
W
Positioner with remote control electronics
②
④
⑥
⑧
⑩
⑫
⑭
②
.
②
through the cable entry of the positioner.
F.2 19" slide-in module
Cable to the valve
Connecting terminals, positioner
Connecting terminals of valve
Cable to control system
Control system
Earth potential
Channel 1 of 3
297