Connecting Ncs To Emc Filter Module - Siemens SIPART PS2 Operating Instructions Manual

B.2.3

Connecting NCS to EMC filter module

Requirement
You need the EMC filter module, article number C73451‑A430‑D23, for the electrical
connection of the accessory part "NCS sensor for contactless position measurement" to the
positioner. The positioner supplies auxiliary power to the NCS sensor via the EMC filter module.
Wiring diagram
①
②
③
④
⑤
⑥
Figure B-7
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
External position detection with NCS or external position detection system
Positioner (open state)
Terminal 71 (Vcc): Yellow
Terminal 72 (Vref): Green
Terminal 73 (Vpos): Black
Terminal 74 (ground): Brown
EMC filter module C73451-A430-D23
Example of connecting the NCS to the EMC filter module
B.2 Non-Contacting Sensor
⑦
Cable clamp
⑧
Screw F3x8
⑨
Cable gland
⑩
Four-pole NCS cable
⑪
Non Contacting Sensor (NCS)
⑫
Cable shielding lug
269