Siemens SIPART PS2 Operating Instructions Manual page 263

Procedure for the part-turn actuator to VDI/VDE 3845
1. Slide the clamping table
2. Mount the clamping table
⑧
3. Depending on the material of the magnet holder, proceed as follows:
4. Screw the NCS
⑫
5. Once the NCS
④
Procedure for part-turn actuators with manufacturer-specific interface
1. Steps 1 to 4 as above.
2. Set a clearance of 3 mm between the top edge of the magnet
mounting console
NCS housing
Reference
For information on the scope of delivery, refer to chapter "NCS sensor scope of delivery
(Page 274)".
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
External position detection with NCS or external position detection system
.
Magnet holder made of glass fiber reinforced
polyester
1. Insert the plastic washer
④
.
④
2. Fix the magnet onto the clamping table
⑨ ④
. The magnet can now be rotated
easily on the clamping table
3. Slide the tensioning ring
④
. Make sure that the spring elements
⑤
and the hook on the magnet
up above one another and that they engage.
You will now have more resistance when
turning the tensioning ring
④
.
⑩
onto the mounting console
⑪
, hex nut and the washer
⑬
is mounted, the clearance of 3 mm between the top edge of the magnet
and the top edge of the mounting console
⑩
. Extend the stub shaft accordingly, or insert washers underneath the
⑬
.
⑨
onto the stub shaft of the part-turn actuator.
⑨
to the stub shaft using a hex socket head screw
Magnet holder made of anodized aluminum
⑥
into the magnet 1. Place the magnet
2. Secure the magnet
⑨
.
①
over the magnet
③
④
are lined 3. Then tighten the two hex socket head screws
①
and magnet
⑩
⑧
.
⑩
B.2 Non-Contacting Sensor
④
onto the clamping table
⑨
.
④
to the clamping
⑨
table by connecting the two parts of the
①
tensioning ring to the two hex socket
②
head screws . The magnet
be rotated easily on the clamping table
② ④
. The magnet can then no longer be
rotated on the clamping table
using the hexagon socket-head screw
is set automatically.
④
and the top edge of the
⑦
and washer
④
can now
⑨
.
⑨
.
263