Siemens SIPART PS2 Operating Instructions Manual page 197

Messages during operation
Message Line
Up Bot‐
tom
CPU X
START X
HW / X
ERROR
NOINI X
nnn.n X
AUTnn X
MANnn X
oFL / X
127.9
EXSTP X
EX UP X
EXDWN X
EXPSt
InPSt
FST X
SRT X
MSRT X
VPT X
LEAKR X
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
Operating mode
Automat‐ Manual P man‐
ic mode ual mode
X X
X
X
X X
X
X
X
X
X
X
X
X
10.1 Output of system messages in the display
Meaning/cause
Message after application of elec‐
trical auxiliary power.
Fault in the hardware.
X Positioner is not initialized.
Actual position [in %] for initial‐
ized positioner. Flashing decimal
point shows communication with
a class 2 master.
Automatic mode (nn = setpoint)
Manual mode
(nn = setpoint)
Display range exceeded.
Possible causes:
● Friction clutch or
● Transmission ratio selector
was moved or
● Positioner was installed on a
different actuator without
being re-initialized.
Actuator was stopped by the bi‐
nary input.
Actuator is moved to the upper
endstop by the binary input.
Actuator is moved to the lower
endstop by the binary input.
The partial stroke test was activa‐
ted, e.g. by the binary input.
Cyclic partial stroke test.
Full stroke test running.
Step response test running.
Multi-step response test running.
Valve performance test running.
A leakage test started by commu‐
nication is running.
Alarm, error, and system messages
Measure
● Wait.
● Replace electronics.
● Start initialization.
● Switch to automatic
mode with
● Offset friction clutch
so that, when the
actuator moves, the
actual value display
stays between 0.0 and
100.0, or
● Switch the
transmission ratio
selector or
● Perform factory
settings (Preset) and
initialization.
.
197