Prst' Preset; Pneum' Pneumatics Type - Siemens SIPART PS2 Operating Instructions Manual

Parameter assignment
9.4 Description of parameters
9.4.2.20

'50.PRST' Preset

Possible settings:
Purpose:
Description:
Factory setting:
See also
Display of diagnostics values (Page 198)
9.4.2.21

'51.PNEUM' Pneumatics type

Requirements:
Possible settings:
164
● ALL
● Init
● PArA
● diAg
Use this parameter to restore the factory settings for most parame‐
ters. The following parameter groups are available:
● ALL: Reset all parameters together which can be reset by 'Init',
'PArA' and 'diAg'.
● Init: Reset initialization parameters '1.YFCT' to '5.INITM'.
● PArA: Reset application parameters '6.SCUR' Current range of
setpoint (Page 150) to '49.\\LIM' Response threshold of fault
message 'Control deviation' (Page 163).
● diAg: Reset parameters A to P of the extended diagnostics as
well as parameter '52.XDIAG' Activating for extended
diagnostics (Page 166).
An overview of the parameters and factory settings can be found in
section Tabular overview of the parameters (Page 139).
In order to select one of the parameter groups listed above, repeat‐
edly press the button until the desired setting is output in the dis‐
play. Start the function by keeping the
is output in the display. The values of the parameter group are now
the factory settings.
If you wish to use a previously initialized positioner on a different
control valve, set the parameters to the factory settings prior to a new
initialization. To do this, use the 'ALL' or 'Init' setting.
Restore the factory settings if you have changed several parameters
at once without being able to predict their effect and the undesired
reactions which may occur as a result. To do this, use the 'ALL' set‐
ting.
ALL
FIP You have a positioner with the "Fail in place" function with
order suffix -Z, order code F01.
booSt You operate the positioner with a booster.
Std Standard pneumatic block
FIP Fail in place pneumatic block
booSt Operation with boosters
button pressed until 'oCAY'
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC