Siemens SIPART PS2 Operating Instructions Manual page 124

Commissioning
7.6 Commissioning part-turn actuators
1. Switch to the "Configuration" mode. To do this, press the
until the display shows the following:
2. Use the
the following:
3. Call the "2.YAGL" parameter. To do this, briefly press the
already been set to 90° automatically. The display shows the following:
4. Call the "4.INITA" parameter. To do this, briefly press the
following:
5. Start the initialization process. To do this, press the
the display shows the following:
The positioner runs through five initialization steps during the automatic initialization
process. Displays for the initialization steps from "RUN 1" to "RUN 5" are shown in the lower
line on the display. The initialization process depends on the actuator used, and takes up
to 15 minutes.
6. The following display indicates that the automatic initialization is complete. The total angle
of rotation of the actuator is shown on the upper line on the display:
124
button to change from linear actuator to part-turn actuator until the display shows
button for at least 5 seconds
button. This parameter has
button. The display shows the
button for at least 5 seconds until
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC