TP-Link TL-WPA4230P Quick Installation Manual

LED Indicators
Power
On: The device is on.
O : The device is o .
Blinking: The device is pairing.
Powerline
On: The device is connected to a powerline network.
O : The device isn't connected to any powerline network.
Blinking: The device is transferring data.
Ethernet
On: At least one Ethernet port is connected.
O : No Ethernet port is connected.
Wi-Fi
O : The wireless function is disabled.
Quick Installation Guide
Blinking quickly: The wireless function is enabled.
Blinking every second: The device is cloning Wi-Fi settings from
a router.
500Mbps
Wi-Fi/Wi-Fi Clone
AV500 Passthrough Powerline WiFi Extender/WiFi Kit Button
A powerline network requires at least two powerline
devices. We use the powerline adapter TL-PA4020P as an
example to work with TL-WPA4230P.
Note
If your home or o ce already has powerline adapters,
remove them rst, install TL-WPA4230P using Method 1
or Method 2, and then add your existing adapters to the
powerline network.
Pair Reset Ethernet
Button Button Ports
2.
Method 1: Plug and Play
Connect your devices as follows.
Create a New Wireless Network
1.
Write down the default wireless network name
(SSID) and password of TL-WPA4230P.
Wireless Network
Name (SSID)*:
TP-LINK_XXXXXX
Wireless Password:
XXXXXXXX
* The default SSID is TP-LINK_XXXXXX. (XXXXXX indicates the last six unique
characters of the WLAN MAC address.)
If the Powerline LEDs don't turn solid, reset all the powerline devices, or create
a powerline network by referring to FAQ-Q1.
Read this to install additional devices
1. Make sure the additional devices use factory default settings. If not,
please reset them.
SSID:
ABCDE 2. Plug them into the outlets and wait about 1 minute until their
Internet
Powerline LEDs turn solid.
TL-PA4020P
LAN WAN
TL-PA4020P
TL-WPA4230P
All the Powerline LEDs will turn
solid within 1 minute.
Installation is completed when all the
SSID:
Powerline LEDs turn solid.
TP-LINK_XXXXXX
If the Powerline LEDs do not turn solid, please follow the instructions in
TL-WPA4230P
FAQ->Q1:
1. For the two devices connected before, use the Pair Button to create a
powerline network (Q1->A). (Skip this step if you have already done this.)
2. For additional devices, use the Pair Button to join the existing powerline
network (Q1->B).
Enjoy!
Use the default SSID
(TP-LINK_XXXXXX) and
password you wrote down
to access the Internet.
Additional
Device
7106504801 REV1.0.0