TP-Link RE210 Quick Installation Manual

Quick
Installation
Guide
AC750 WiFi Range Extender
RE210
Two easy setup options:
Option 1: Using WPS (Wi-Fi Protected Setup)
Option 2: Using a Web Browser
1
Using WPS (Wi-Fi Protected Setup)
Important: Please use Option 2 if your router does not support WPS.
1 Power On
Plug the extender into an electrical outlet
near your router, and wait until the Power
LED is lit and solid green.
3 Relocate
A. Plug the extender into an electrical outlet
about halfway between your router and the
Wi-Fi dead zone.
B. Wait about 1 minute until the
and stay solid.
Solid green
Good
connection
Choose a location away from Bluetooth devices and
other household electronics, such as cordless phone,
microwave, and baby monitor, etc., to minimize
signal interference.
Entertainment Adapter
The Range extender can be used as a wireless
adapter to connect any Ethernet-enabled device,
such as a Blu-ray player, game console, DVR, or smart
TV, to your wireless network.
First, connect the extender to your Wi-Fi network by
following the instructions in Option 1 or Option 2,
then connect an Ethernet-enabled device to the
extender using an Ethernet cable as shown in the
diagram on the right.
2 Connect
A. Press the WPS button on your router/AP and immediately press the RE button on your extender.
B. If you are connecting the extender to a dual-band router, but only
RE LED is lit
Solid red Solid orange
Too far away Too close to
from the router the router
Ethernet Connection
Smart TV
LEDs
(RE)
Blinking green: WPS connection is in progress.
Solid green: The extender is connected to the
router and is in a good location.
Solid orange: The extender is connected to the
router, but is too close to the router.
Solid red: The extender is connected to the router,
but is too far away from the router.
O : No active connection.
For more information about using WPS on your router,
please refer to the router manufacturer's user guide.
is on, repeat step A to connect the other band.
Main Network
Ideal Range Extender Placement
Both 2.4GHz and 5GHz extended networks share the same SSID (network name) and password as your main network.
Keep away from
Game Console Desktop
(Power)
On/O : The extender is on or o .
Blinking: The extender is initializing.
(2.4GHz)
On: The extender is connected to the 2.4GHz
wireless network of your main Router/AP.
O : No connection.
(5GHz)
On: The extender is connected to the 5GHz
wireless network of your main Router/AP.
O : No connection.
The
from blinking to a solid state after
about 1 minute, indicating that
WPS connection is successful.
If not, please use Option 2.
2.4GHz or
Extended Network
5GHz
2.4GHz
RE LED should change
5GHz LED
Enjoy!
Router