Comtrend Corporation GCA-6000 Quick Install Manual

Quick Install Guide
GCA-6000| G.hn Ethernet over Coax Adapter
Understanding Your G.hn Coax Adapter
A
Coverage LED:
Adapters are paired when lit
NOTE: The following steps show how to create or add onto a G.hn Coax Network (A minimum of two G.hn Coax Adapters are
required to create a proper connection.)
 If this is the first time you are setting up a G.hn Coax Network please continue to Section B.
 If you already have an established G.hn Coax Network, and are adding an additional adapter please skip to Section C. Follow
Steps 4-8 to add additional G.hn Adapters to your network.
B
Creating a New G.hn Coax Network
1. Plug the power supply into the Coax Adapter and into the power outlet nearest to the network device (Eg. Modem, Router, or
Access Point). The LEDs will briefly turn on.
2. Connect the coaxial cable to the "IN" of the Coax Adapter and to a cable wall outlet.
3. Ensure that your network device is powered on. Connect the Coax Adapter to the LAN port of the network device with an
Ethernet cable. Wait for 10 seconds for the Coax Adapter's Ethernet LED
Coaxial Cable
Connection is secure when lit
Ethernet LED:
Directly connected device is active
when blinking
Power Adapter
Power Adapter
Security LED:
Power Plug
to light up GREEN
Network Device
(Modem, Router, or Access
Ethernet Cable
Configuration
Button
Gigabit
Ethernet
Port
indicating a stable connection.
Point)
Page 1