Inverter Configuration Menu Options - SolarEdge SE3000US Installation Manual

Inverter Configuration Menu Options

1
Select the 1. Country option to specify the country in which the inverter is
installed. This parameter may arrive pre-configured. If so, verify that it is set
to the proper country.
WARNING!
The inverter must be configured to the proper country in order to ensure that it
functions properly with that country's grids.
L'onduleur doit être configuré pour le pays approprié afin d'assurer un
fonctionnement convenable avec le réseau de ce pays.
NOTE:
If an inverter is not configured to any country, then it does not turn ON.
If no country is configured, its value is <NONE>. A list of countries is
displayed. A + near the country indicates that another menu will be displayed
after selection.
The following is an example of the parameters that appear after USA+ is
selected.
* 1 .
2 .
3
4 .
5
6
After selecting the country, you are asked to confirm your selection in the
confirmation screen. Toggle to YES and press Enter to confirm.
If the No Neutral option is not selected, you must connect the Neutral line.
The Neutral line is used to verify the phase balance between L1-N and L2-N.
Auto: This setting requires the Neutral line to be connected. When this
option is selected, the inverter automatically detects whether a 208VAC or a
240VAC grid is used. Refer to page 34 about which grids can be
automatically configured.
•
208V: This setting requires the Neutral line to be connected and
indicates the use of a 208V Delta grid.
•
240V: This setting requires the connection of the Neutral line and
indicates the use of a 240V split phase grid or a 240V Delta grid.
•
208V No Neutral: Indicates the use of a 208V grid between L1 and L2
with no need for a neutral connection
SolarEdge Installation Guide – MAN-01-00002-1.6
A u t o
2 0 8 V
2 4 0 V
2 0 8 V N o
2 4 0 V N o
2 7 7 V
Inverter User Interface
N e u t r a l
N e u t r a l
95