Solid-State Drive Bracket And Connector Board - HP 15 Maintenance And Service Manual

Solid-state drive bracket and connector board

Description
Solid-state drive bracket
Solid-state drive connector board
Solid-state drive cable
Before removing the solid-state drive bracket and connector board, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
7. Remove the solid-state drive (see
Remove the solid-state drive bracket and connector board:
1. Slide the bracket toward the side of the computer (1), and then lift the bracket out of the computer (2).
2. Disconnect the solid-state connector board cable from the system board ZIF connector (1).
3. Remove the Phillips M2.0×3.0 screw (2) that secures the board to the computer.
Optical drive on page
Bottom cover on page
Battery on page 40).
Solid-state drive on page
33).
37).
46).
Component replacement procedures
Spare part number
L20458-001
L22542-001
L20456-001
47