Adjusting The Display; Enabling/Disabling Wireless Connectivity - Accu-Chek Inform II Operator's Manual

42

Adjusting the display

Display
Lighter
03/17/17
Enabling/disabling wireless
connectivity
Using the Display options, you can adjust the display con-
trast to the ambient light conditions.
1
12:48 pm
2
3
Darker
After 30 seconds without any activity (e.g., without a
screen touch) the meter automatically dims the display
backlight to conserve energy ("Low Power Mode").
If the meter supports wireless connectivity, you can tem-
porarily enable or disable this functionality as required.
Wireless connectivity is automatically reactivated the next
time you power on the meter. You can then disable it
again temporarily, if required.
If you suspect that the RF emissions of wireless commu-
nication are harming the patient or affecting other
devices, you should carefully reassess the appropriate-
ness of continued use of the WLAN functionality of the
Accu-Chek Inform II system using the guidelines of your
facility.
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator's Manual Version 6
In the Power Up screen, touch Contrast. The Display
screen appears.
Touch or to make the display lighter or
darker.
Touch to confirm the setting.
WARNING