SolarEdge SE7600A-US Installation Manual page 9

WARNING!
The inverter must be connected to a dedicated AC branch circuit with a maximum Overcurrent
Protection Device (OCPD) of 50A.
Les onduleurs monophasé doivent être connectés à un branchement AC dédié avec un disjoncteur de
50A.
CAUTION!
This unit must be operated according to the technical specification datasheet provided with the unit.
Cette unité doit être utilisée selon les spécifications de fonctionnement, comme décrit dans la dernière
fiche technique des spécifications.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting techniques, and if required - a
lifting aid when removing or replacing.
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez des techniques de levage
appropriées et, si nécessaire - un auxiliaire de levage lors du retrait ou du remplacement.
NOTE
The Connection Unit is NEMA type 3R rated . Unused conduit openings and glands should be sealed
with appropriate seals.
NOTE
Use only copper conductors rated for a minimum of 75°C/ 167°F.
NOTE
This inverter is provided with an IMI (Isolation Monitor Interrupter) for ground fault protection.
NOTE
The symbol
this manual.
NOTE
A SolarEdge inverter may be installed in a site with a generator, however must not operate at the same
time as the generator. Operating an inverter and a generator simultaneously will void the warranty.
SolarEdge requires installing a physical or electronic interlock, which will prevent the generator and
inverter from operating simultaneously. Interlock procurement, installation, maintenance and support
are the responsibility of the installer. Damage to the inverter due to incorrect interlock installation or use
of an interlock that is incompatible with the SolarEdge system will render the SolarEdge warranty
invalid.
WARNING!
Shutting off the AC breaker does not disable the DC voltage inside the inverter. To obtain safe DC
voltage, turn off the inverter ON/OFF switch and the Connection Unit ON/OFF switch.
En mode autonome, la fermeture du coupeur CA n'élimine pas la tension CC à l'intérieur de l'onduleur.
Afin d'obtenir une tension CC sécurisée, mettez l'interrupteur du coupeur CC de l'onduleur et celui du
coupeur CC de l'unité StorEdge en position OFF.
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.3
appears at grounding points on the SolarEdge equipment. This symbol is also used in
IMPORTANT INVERTER SAFETY INSTRUCTIONS
7