Chapter 9: Setting Up Communication To The Monitoring Platform - SolarEdge SE7600A-US Installation Manual

Chapter 9: Setting Up Communication to the Monitoring Platform

Chapter 9: Setting Up Communication to the
Monitoring Platform
Power optimizers send information to the inverter via the DC power lines (the PV output circuit). T he
information is sent from the inverter to the SolarEdge monitoring platform through the Internet. In
order to send the data from the inverter, a communication connection must be set up, as described in
this chapter.
CAUTION!
When connecting the communication cables, make sure that the ON/OFF switch at the bottom
of the inverter is turned OFF, and the AC is turned OFF.
When configuring the communication parameters, make sure that the ON/OFF switch is OFF,
and the AC is turned ON.
Lors de la connexion des câbles de communication, assurez-vous que l'interrupteur
MARCHE/ARRÊT à la base de l'onduleur soit en position ARRÊT, et le CA est en position
ARRÊT. Lors de la configuration des paramètres de communication, assurez-vous que
l'interrupteur MARCHE/ARRÊT soit en position ARRÊT, et le CA est en position MARCHE.
72
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.3