CPU: The communication board firmware version
l
Country: the current country setting
l
Server Communication Status
S e r v e r : L A N
S t a t u s :
x x x x x x x x
< E R R O R
NOTE
If the connection method is CDMA (refered to as "Cellular" in the status screens) or GSM, the server
screen is replaced with the Cellular or GSM status screens (see Cellular Status on page 68 and
GSM Status on page 68).
Server: The method of connection to the SolarEdge monitoring platform.
l
S_OK: The connection to the SolarEdge monitoring platform is successful (should appear only if the i s
l
connected to the server).
Status: Displays OK if the inverter established successful connection and communication with the
l
specified server port/ (LAN, RS485 or ZigBee card).
xxxxxxxx: Eight-bit Ethernet communication connection status: A string of 1s and 0s is displayed. 1
l
indicates OK, 0 indicates an error. F or a list of the possible errors and how to troubleshoot them, refer
to Communication T roubleshooting on page 93.
Error message, according to failure. Refer to Troubleshooting on page 93.
l
IP Status
This screen describes the Ethernet configuration: IP, Mask, Gateway and MAC address (Media Access
Control) of the Inverter.
I P
1 9 2 . 1 6 8 . 2 . 1 1 9
M S K
2 5 5 . 2 5 5 . 2 5 5 . 0
G W
1 9 2 . 1 6 8 . 2 . 1
M A C
0 - 2 7 - 0 2 - 0 0 - 3 9 - 3 6
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.3
< S _ O K >
< O K >
M E S S A G E >
Chapter 8: User Interface
67