System Warnings - SolarEdge SE7600A-US Installation Manual

Error code
CPU v3.18 CPU v3.19
and below and above
196 2xC4
0x2010

System Warnings

Warnings are displayed in the initial status screen with the format: <Warning X>. For example:
V a c [ V ]
1 . 0
P _ O K : X X X / Y Y Y
W a r n i n g
The warning is a status screen. To view the warning description, press the LCD button.
The following is a list of system warnings:
Warning #
CPU v3.18xx CPU v3.19xx
and before and later
8x66 - 8x69
1-4, 6-7
8x6A - 8x6F
5
8 2x111
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.3
LCD message
Backup init over
voltage
Internal CB down
V d c [ V ] P a c [ W ]
0 . 5 0 . 0
< S _ O K >
8 O N
LCD text
Fan # Failure
Turn Switch Off to Configure
Connection Unit Low 9V Battery
Cause and Troubleshooting
External voltage source on backed-up loads when
o
operating in Backup mode. Disconnect all external
voltage sources on backed-up loads.
Inverter internal error. Contact SolarEdge support.
o
Make sure that the loads do not consume higher
current than the inverter max output current. Open the
inverter Connection Unit and switch the main circuit
breaker to the ON position.
Comments and troubleshooting
Clean or replace the fan
Appears when trying to access the
Setup menus during production
Replace the 9V battery in the
Connection Unit. Refer to 9V Battery
Replacement on page 104.
Appendix A: Troubleshooting
101