List Of Diagnostics Events With Status And Diagnostics Message For Activated Condensed Status - Siemens SIPART PS2 PA 6DR55 Series Operating Instructions Manual

1 74
2 75
76 ... 80
4 0 81
1 82
2 83
3 84
4 85
5 86
6 87
88 ... 96
11.3.4.7 List of diagnostics events with status and diagnostics message for activated condensed
status
A list of diagnostics events with status and diagnostics message for activated condensed
status is given in the following table. DIAGNOSTICS_EXTENSION and
DIAGNOSTICS_EXTENSION_2 are physical block parameters.
Different status and diagnostics messages can be allocated to individual diagnostics events
as per the following tables. The frame in which an allocation is possible is defined by the
group in the selection column. The following principle is used: in case of three-stage
diagnostics events of the MAINTENANCE group, the effect of the higher lever events can be
downgraded, but that of the lower level events cannot be upgraded.
DIAGNOSTICS_EXTENSION physical block parameter
Byt Bit No. Diagnostics events
e
0 0 1 Run time error of the
actuator
1 2 The device is not in the
"Automatic mode"
2 3 Binary 1 is active (only
message)
3 4 Action triggered by
binary input 1
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
PST reference time exceeded
(limit 2)
PST reference time exceeded
(limit 3)
Reserved
Permissible device
temperature exceeded (limit 1)
Permissible device
temperature exceeded (limit 2)
Permissible device
temperature exceeded (limit 3)
Permissible device
temperature undershot (limit 1)
Permissible device
temperature undershot (limit 2)
Permissible device
temperature undershot (limit 3)
Limit for dead zone monitoring
exceeded
Reserved
Quality status code
Good, Ok
Good, check function /
manual mode
Good, Ok
Good, Ok
Functions/operations using PROFIBUS PA
Hard-coded effect of a diagnostics event
Good, maintenance required
Good, maintenance required
-
Good, maintenance required
Good, maintenance required
Good, maintenance required
Good, maintenance required
Good, maintenance required
Good, maintenance required
Good, maintenance required
-
Effect of the event
DIAGNOSTICS bit
DIA_MAINTENANCE_ALARM
DIA_FUNCTION_CHECK
DIA_MAINTENANCE_DEMAND
ED
DIA_FUNCTION_CHECK
11.3 Cyclic data transfer
DIA_MAINTENANCE
DIA_MAINTENANCE
-
DIA_TEMP_ELECTR
DIA_TEMP_ELECTR
DIA_TEMP_ELECTR
DIA_TEMP_ELECTR
DIA_TEMP_ELECTR
DIA_TEMP_ELECTR
DIA_TEMP_ELECTR
-
1)
M
F
M, F, P
M, F, P
Group
213