Table of Contents
Advertisement
UPDATING THE WINEGARD
When first setting up the Winegard ConnecT it is recommended to check for
software updates the first time the system is connected to an Internet signal.
It is also recommended to check for updates every couple months for fixes
and added features.
NOTE:
To retain all passwords and name changes during updates, click "Keep Settings".
From the Status Screen, choose UPDATE SOFTWARE from the drop down
1)
menu and click SELECT.
NOTE:
Updating the system software from the network will require the Winegard
ConnecT to be connected to an internet source.
Once on the update software screen, click CHECK FOR LATEST VERSION.
2)
See Figure 11.
There will be a slight delay while the Winegard ConnecT compares the
3)
current software version to the latest available version. If you have the latest
version there is no need to update the software, click CANCEL. If the check
finds that you have older software, click PROCEED to update to the latest
version. See Figure 12.
If you clicked PROCEED, the system will unavailable for several minutes
4)
while the outdoor antenna resets. As it powers back on, the system will
function normally.
NOTE:
During this reset, your device may switch to a local remembered WiFi
network. This will not allow you to return to the ConnecT setup screens. If this
happens, simply reconnect manually to the ConnecT's SSID again from your device.
Return to Factory Defaults
To return to factory default, press the reset button located on the left side of
the power inserter for 30 seconds. See Figure 4.
WARNING:
All changes will be lost and unit will return to factory default
SSID and password. To begin setup, please refer to quick start guide.
:
Maintenance
Periodically check the ODU to ensure all connections are tight.
As with all electronics, cycle power every few days to keep things running smoothly.
WINEGARD
CONNECT
®
Troubleshooting
LED DEFINITION:
LED Off
Solid Red
Slow Orange Blink
Fast Orange Blink
Slow Red Blink
Fast Red Blink
Solid Green
Fast Green Blink
Alternating Green & Orange Blink
5
CONNECT
™
®
SUPPORT
™
System is powered down.
The Winegard ConnecT is booting up.
The Winegard PoE is searching for an ODU.
The Winegard PoE reset button was pressed for 10 seconds.
The Winegard PoE is connected to something other than the ODU in the "To Antenna" port.
The Winegard PoE reset button was pressed for more than 30 seconds.
The Winegard PoE has found the ODU and it is powered up.
The Winegard PoE reset button was pressed for less than 10 seconds.
Power may have been removed during an update and the Winegard ODU is in rescue mode. Please contact
Winegard at 1-800-320-9992.
SOFTWARE
Figure 11
Figure 12
Advertisement
Table of Contents
