Dual-Flame Stacked Burners - GE ZGP304 Owner's Manual

Dual-flame Stacked Burners

burner head, and burner cap. The burner head and
burner cap can be lifted off, making them easy to clean.
CAUTION
Surface burners should be cleaned routinely, especially
after bad spillovers, which could clog the slots and holes
in the burner heads.
The electrode is located at the rear of each burner. Do
not attempt to disassemble or clean around any burner
while another burner is on. An electric shock may result.
Electrode
To remove the burner parts:
1. Turn all controls OFF before removing any burner
parts.
2. When cool, you may lift off the burner grates, burner
caps and burner heads for easier cleaning. Do not
remove the burner bases.
NOTE: The ZGP304 model has 2 different size burners.
Be sure to replace the burners in the same location.
49-85244
Burner Cap
Burner
Head
Burner
Base
Cleaning
Lift off burner parts only when cool. Wash in hot, soapy
water. You may use a plastic scouring pad to remove
burned-on food particles.
To remove burned-on food, soak the burner heads in
a solution of mild liquid detergent and hot water for
20–30 minutes. For more stubborn stains, use a plastic
scouring pad or toothbrush.
If the spill goes inside the burner head assembly, wash it
under running water and shake to remove excess water.
After Cleaning
Before replacing the burner parts, shake out excess
water and then dry them thoroughly.
To replace the burner parts:
Make sure that the burner parts are replaced in the
correct location.
1. Replace the burner head on top of the burner base,
making sure that the hole in the burner head is
properly aligned with the electrode in the burner base.
A small gap between the base and head is normal.
2. Place the burner cap on top of the burner head. Make
sure that the burner cap is properly seated on the
burner head.
Burner cap properly seated
Burner cap not properly seated
31