Assembly Preparation; Lg860Bi (Built-In) Instructions; Preparing The Support Structure - Louisiana Grills LG860C Instructions And User Manual

Estate series wood pellet grill & smoker

Manual (98 pages)

Table of Contents

Inspect the grill after removing the protective shipping carton, and report any damage to your dealer immediately. Shipping

damage is not covered under warranty.

Before assembly of product, review parts list. If any part is missing or damaged, do not attempt to assemble the product. Contact

your dealer or Customer Service for parts.

Tools required for assembly: screwdriver and level. Level not included.

MAJOR CAUSES OF APPLIANCE FIRES ARE A RESULT OF POOR MAINTENANCE AND A FAILURE TO

MAINTAIN REQUIRED CLEARANCE TO COMBUSTIBLE MATERIALS. IT IS IMPORTANT THAT THIS

PRODUCT BE INSTALLED IN ACCORDANCE TO THE FOLLOWING INSTRUCTIONS.

Building an outdoor kitchen is possible with the right planning and measurements. Good air ventilation, clearance from

combustibles, and proper care and maintenance are key factors to consider before installation.

IMPORTANT: As a built-in project is complex, we recommend knowing the dimensions of your appliance before

attempting installation. It is also highly recommended to seek assistance of trade professionals when planning your

outdoor cooking space. As simple or elaborate as your project may be, each contractor will have concerns regarding the

placement of materials, safety clearances, proper ventilation, electric routing, etc.

1. PREPARING THE SUPPORT STRUCTURE

The unit has been designed to sit in a cavity, or

cutout, of an outdoor kitchen. Planning and proper

care should be made to ensure there is sufficient

air ventilation for the unit to operate properly in

the support structure. Note illustration 1A.

Prepare a masonry support structure, such as

brick, building stone, cast stone, or concrete

block.

Other

non-combustible

structures, such as cement base board, metal

studs or framing may also be used. The unit can be

installed without additional insulation; however,

proper care must be taken to ensure that it is not

installed under or on any combustible materials.

Parts Required:

Air Register Vent Cover (#A1)

Installation:

•

Install the air register vent covers to the

air ventilation openings. Choose a fastener

appropriate to your support structure

material (hardware not included).