Table of Contents
Advertisement
2. Setting Up the Printer
5.
Fully insert the IEEE 1284 interface board.
Check that the IEEE 1284 interface board is firmly connected to the controller board.
6.
Tighten the two screws to secure the interface board.
7.
Plug in the power cord, and then turn on the printer.
8.
Print the configuration page to confirm that the board was attached correctly.
• Check that the board was correctly installed by printing the configuration page. If it is correctly
installed, "Parallel Interface" will appear for "Device Connection" on the configuration page. For
details about printing the configuration page, see page 100 "Test Printing".
• If the board was not installed properly, repeat the procedure from the beginning. If it cannot be
installed correctly even after trying the installation a second time, contact your sales or service
representative.
Installing SD Card Options
This procedure is applied to SP C342DN only.
66
DPP030
DPP031
midas-p3_com_operating_instructions_gb_00198474_eng.xml
Draft 2016/01/18
Advertisement
Table of Contents
