Siemens SIPART PS2 Operating Instructions Manual page 45

3. Push the coupling wheel
4. Place the carrier
SIPART PS2 with and without HART
Operating Instructions, 02/2016, A5E00074631-AB
Pointer mark
positioner shaft. Then retract the coupling wheel or the stainless steel coupling by
approximately 1 mm. Tighten the hexagon socket-head screw
wrench provided. Maximum tightening torque = 1 Nm. If you are using the stainless steel
coupling, omit the next step.
Note
Coupling wheel
Instead of the plastic coupling wheel
(article number TGX: 16300-1556).
Coupling wheel
②
on the stump of the actuator shaft. Tighten the carrier
⑨
socket cap screw and the washer
Pointer mark, flameproof enclosure
①
or the stainless steel coupling up to the endstop on the
①
, it is possible to use a stainless steel coupling
Coupling wheel, flameproof enclosure
⑩
.
Installing/mounting
4.3 Mounting the part-turn actuator
⑪
using the machinist's
②
using the
45