Diagnostic Value '57.Ma - Setpoint Current; Online Diagnostics; Overview Of Online Diagnostics - Siemens SIPART PS2 Operating Instructions Manual

Alarm, error, and system messages

10.3 Online diagnostics

Travel range
Travel range section [%]
Division of travel ranges
10.2.4.32

Diagnostic value '57.mA - Setpoint current'

Here you can display the current setpoint in mA.
10.3 Online diagnostics
10.3.1

Overview of online diagnostics

Online diagnostics means diagnostics during ongoing operation. During operation of the
positioner, a few important values and parameters are continually monitored. In configuration
mode, you can configure that monitoring so that the fault message output will be activated if,
for instance, a limit is exceeded.
Information about what events can activate the fault message output can be found in the
table in section "Overview of error codes (Page 226)".
This section contains particular information about the following situations:
● Possible causes of the fault message.
● Events which activate the fault message output or alarm outputs.
● Settings of parameters needed for event monitoring.
● Cancelling an error message
When the fault message output is triggered in "Automatic" or "Manual" mode, the display
shows which fault triggered the message. The two digits on the lower left show the
corresponding error code. If multiple triggers occur at the same time, they are displayed one
after the other cyclically. The device status, including all fault messages, can be called up
using command "#48" over HART.
224
WT00 WT05 WT10
- ≥ 5 ≥ 10
< 5 < 10 < 30
You can simultaneously set the eight operating hours counters to
zero.
TIP: Since the travel ranges are provided at the end of the diag-
nostics parameters, press the
key. This will help you to access the desired diagnostics pa-
rameters faster.
WT30 WT50 WT70
≥ 30 ≥ 50 ≥ 70
< 50 < 70 < 90
key several times along with the
SIPART PS2 with and without HART
Operating Instructions, 02/2016, A5E00074631-AB
WT90 WT95
≥ 90 ≥ 95
< 95 -