Usb Port Board Cable - HP 15-cc000 Maintenance And Service Manual

USB port board cable

NOTE: The USB port board spare part kit does not include the USB port board cable. The USB port
board cable is available using spare part numbers 926842-001.
Before removing the USB port board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the optical drive (see
a. Bottom cover (see
b. Battery (see
c. Solid-state drive (see
d. Fan (see
e. System board (see
Remove the USB port board cable:
1. Turn the system board upside down with the front toward you.
2. Release the ZIF connector (1) to which USB port board cable is connected, and then disconnect the USB
port board cable (2) from the audio jack board.
3. Remove the USB port board cable.
Reverse this procedure to install the USB port board cable.
Optical drive on page
Bottom cover on page
Battery on page 38)
Solid-state drive on page
Fan on page 49)
System board on page
35), and then remove the following components:
36)
43)
50)
Component replacement procedures 57