Heat Sink - HP 15-cc000 Maintenance And Service Manual

Heat sink

NOTE: The heat sink spare part kit includes replacement thermal material.
Description
For use only on computer models equipped with a graphics subsystem with discrete memory
For use only on computer models equipped with a graphics subsystem with UMA memory
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the optical drive (see
a. Bottom cover (see
b. Battery (see
c. Solid-state drive (see
d. Fan (see
e. System board (see
Remove the heat sink:
NOTE: Steps 1 and 2 apply to computer models equipped with a graphics subsystem with discrete memory.
See Steps 3 and 4 for heat sink removal information for computer models equipped with a graphics
subsystem with UMA memory.
1. Remove the six Phillips PM2.0×2.9 screws (1) that secure the heat sink to the system board.
54 Chapter 5 Removal and replacement procedures
Optical drive on page
Bottom cover on page
Battery on page 38)
Solid-state drive on page
Fan on page 49)
System board on page
35), and then remove the following components:
36)
43)
50)
Spare part number
926847-001
926846-001