Usb Port Board - HP 15-cc000 Maintenance And Service Manual

2. Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install a memory module.

USB port board

Description
USB port board (includes power light actuator, hard drive light actuator, card reader slot, and USB port;
does not include USB port board cable)
NOTE: The USB port board cable is available using spare part number 926842-001.
Before removing the USB port board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
Remove the USB port board:
1. Release the ZIF connector (1) to which the USB port board cable is connected, and then disconnect
the USB port board cable from the USB port board.
Memory modules are designed with a notch to prevent incorrect insertion.
Optical drive on page
Bottom cover on page
Battery on page
35).
36).
38).
Component replacement procedures
Spare part number
926854-001
45