Solid-State Drive - HP 15-cc000 Maintenance And Service Manual

Solid-state drive

Description
512-GB, 2280 M.2, SATA-3, solid-state drive with TLC
256-GB, 2280 M.2, SATA-3, solid-state drive with TLC
128-GB, 2280 M.2, SATA-3, solid-state drive with TLC
256-GB, 2280 M.2, SATA-3, solid-state drive
128-GB, 2280 M.2, SATA-3, solid-state drive
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.3 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the solid-state drive.
Optical drive on page
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
35).
36).
38).
Component replacement procedures
Spare part number
763008-019
760615-038
759848-018
865902-019
827560-050
43