Related Manuals for Behringer Ultra-G
Summary of Contents for Behringer Ultra-G
- Page 1 User’s Manual Version 1.0 September 2001 DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:43...
- Page 2 Welcome to BEHRINGER! directly inject DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:43...
- Page 3 In order to avoid damage to your loudspeakers, always mute the corresponding channel on the consoles before connecting the GI100. The same applies when switching between phantom and battery power. DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:43...
-
Page 4: Battery Compartment
CONTROLS Fig. 1.1: The GI100’s front and back panels SIMULATOR ON/OFF GND LIFT OUTPUT TO MIXER You should never connect pins 2 or 3 with pin 1 or remove the shield from pin 1. Otherwise, it will not be possible to operate the unit with phantom power. - Page 5 Before using the PAD switches, be sure that the ULTRA-G is clip- ping, and not the mic preamp on the console. You should only attenuate the input signal via the GI100’s PAD switches if its CLIP LED lights up frequently or remains lit. If this is not the case and distortion occurs, check the console settings.
-
Page 6: Connection Examples
CONNECTION EXAMPLES 2.1 Conversion of guitar signals Fig. 2.1: 1. Guitar ß GI100 ß Console 2. Guitar ß Tube amplifier ß GI100 ß Loudspeaker/Console DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:43... - Page 7 2.2 Picking up a bass guitar or keyboard signal Fig. 2.2: 1. Bass guitar ß GI100 ß Amplifier/Console 2. Keyboard ß GI100 ß Amplifier/Console DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:43...
- Page 8 2.3 Converting a microphone signal from high-impedance unbalanced to low-impedance balanced 2.4 Picking up a signal from a loudspeaker output DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:43...
-
Page 9: Specifications
SPECIFICATIONS BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made from time to time to existing products without prior notice. Specifications and appearance may therefore differ from those listed or shown. -
Page 10: Return Authorization Number
The warranty does not cover any such modification/adaptation, irrespec- tive of whether it was carried out properly or not. Under the terms of this warranty, BEHRINGER shall not be held responsible for any cost resulting from such a modification/adaptation. -
Page 11: Warranty Transferability
5. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. 6. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. - Page 12 BEHRINGER Spezielle Studiotechnik GmbH. BEHRINGER, ULTRA-G and ULTRA-DI are registered trademarks. BEHRINGER Instrument Amplification is a Division of BEHRINGER. ALL RIGHTS RESERVED. © 2001 BEHRINGER Spezielle Studiotechnik GmbH.