Table of Contents
Advertisement
Quick Links
BeamLink 5834, CT-5834, 5834, WL5538AP,
WAP-5834
Wireless Extender
QUICK
INSTALLATION
GUIDE
Introduction
This Quick Installation Guide will help you to quickly and easily install
your Wireless Extender units by performing the few simple steps
described below. Before you begin, check that you have:
• One WAP-5834 Access Point unit (An "AP" is stated in chassis
label)
• One WAP-5834 Client unit (A "Client" is stated in chassis label)
• Two CAT5 ETHERNET cables
• Two power adapters
• One Quick Installation Guide
Easy Link
Step 1 - Power connection
Plug in the power adapter included in your package, and connect
it to the WAP-5834 AP and Client device.
1
Advertisement
Table of Contents
Related Manuals for Comtrend Corporation WAP-5834
Summary of Contents for Comtrend Corporation WAP-5834
-
Page 1: Wireless Extender
Wireless Extender units by performing the few simple steps described below. Before you begin, check that you have: • One WAP-5834 Access Point unit (An “AP” is stated in chassis label) • One WAP-5834 Client unit (A “Client” is stated in chassis label) •... -
Page 2: Step 2 - Placement And Connections
WAP-5834 device may cause damage and void the warranty for this product. Step 2 - Placement and connections The WAP-5834 AP and Client device in your package are pre-configured to work together. Place the WAP-5834 AP device on an easily accessible surface near the Home Gateway or Cable/DSL Modem. - Page 3 LED on the WAP-5834 AP is flashing blue. Power Place the WAP-5834 Client device on an easily accessible surface near the set top box. B. Plug one end of the Ethernet cable into the LAN port of the set top box device and the other end into the Ethernet port of the WAP-5834 Client.
- Page 4 Pairing The WAP-5834 AP and Client device in your package are pre-configured to work together. To add additional WAP-5834 Clients you will need to perform the pairing procedures as explained below. Place the WAP-5834 Client device between 1 to 3 meters from the WAP-5834 AP device.
-
Page 5: Troubleshooting
Step 2. Wait for the pairing process to complete by watching the LEDs on the devices: The LEDs will flash blue for a few seconds. After successful pairing the Wireless LEDs will change to solid blue, and after two minutes turn off. The LEDs will then be solid blue. -
Page 6: Advanced Setting
Change AP or Client mode This is to enable users to change WAP-5834 to AP or Client in a real situation. Note: • If you are connecting to the WAP-5834 directly from a PC, be sure to set a static IP in the same range as the AP or Client unit (e.g. -
Page 7: Advanced Troubleshooting
The WPS function is not working Make sure that: • The WPS function is activated in the AP device. a. Enter into WAP-5834 AP Web GUI through browsers such as IE by default IP address 10.0.0.2. b. Type default username and password: root/12345 c. - Page 8 d. Enable WPS in WPS setting and press the “Apply” button. • Complete the pairing procedures as described in the Pairing section. • LED is not on Wireless • Make sure that you have completed a successful pairing procedure as described in the Pairing section. FOR MORE HELP: If you have further questions or require personal assistance, please contact your equipment provider.
- Page 9 This equipment also should be installed and operated with minimum distance 20cm between the radiator & your body. This device within the 5.15~5.25 GHz band is restricted to indoor operations to reduce any potential for harmful interference to cochannel MSS operations. The range of product's temperture is -20℃...