SolarEdge SE3000 Installation Manual page 73

NOTE:
Please have these numbers ready when you contact SolarEdge support.
5
Select the Communication option to define and configure the
communication option used by the inverter to communicate with the
SolarEdge Monitoring Server.
S e r v e r < L A N >
B u s < Z i g B e e >
L A N
R S 4 8 5
Z I G B E E
R S 2 3 2
M o d b u s

Select option Server to select which communication method is used to
communicate between this inverter and the SolarEdge Monitoring Portal.

Select options LAN, RS232, RS485 or Zigbee to configure the
communication method to the SolarEdge Monitoring Portal. Refer to
Chapter 6, Setting Up Communication on page 45 for a full description
of these communication options:
You can also select the None option if no server communication is required.
NOTE:
This menu shows only the actual communication options installed in the inverter,
based on the ordering options selected. If a communication option is not installed
in the inverter, the relevant number does not appear in the menu.
6
Select the Counters option to reset all telemetry counters that are displayed
in the Energy Meter window, which is described in the Energy Meter
Window section on page 64.
T h i s
R e s e t
P l e a s e
7
Single phase inverters: Select the Phase Balance option to enable/disable the
inverter's power balancing option, which enables the connection of three
single-phase inverters to a three-phase grid.
8
Select the Info option to display the Printed Circuit Board ID and the
inverter's firmware version numbers.
9
Select the Factory Reset option to perform a general reset of the inverter to
its default settings.
SolarEdge Installation Guide – MAN-01-00057-2.0
C o n f
C o n f < S >
C o n f < S >
C o n f
C o n f
a c t i o n
a l l
S e l e c t : N O
Inverter User Interface
w i l l
c o u n t e r s
73