Inverter Configuration Menu Options - SolarEdge SE3000 Installation Manual

Inverter Configuration Menu Options

1
Select the Country option to specify the country in which the inverter is
installed. This parameter may arrive pre-configured. If so, verify that it is set
to the proper country.
WARNING!
The inverter must be configured to the proper country in order to ensure that it
functions properly with that country's grids.
NOTE:
If an inverter is not configured to any country, then it does not turn ON.
If no country is configured, its value is <NONE>. A list of countries is displayed.
A + near the country indicates that another menu will be displayed after selection.
After selecting the country, you are asked to confirm your selection in the
confirmation screen. Toggle to YES and press Enter to confirm.
2
Select the Language option to select the language in which the LCD panel
should display. The inverter may arrive pre-configured to the local language.
3
Select the Temperature option to select the units in which the temperature is
displayed, as shown below:
The display shows either <C> or <F> according to whether Celsius or
Fahrenheit was selected. The default is Celsius.
4
Select the Display option to display the following three options:

LCD On Time <30>: Specifies the number of seconds that the LCD
panel backlight is ON after the LCD light button is pressed. <30>
represents the default value of 30 seconds.

TLM On Time <15>: Specifies the number of minutes that the LCD
panel backlight is ON while viewing the Telemetry window. The default
is 15 minutes.

SW Version: Displays version information describing various firmware
inverter processors, as follows:
I D
D S P 1
D S P 2
C P U

ID: Displays the inverter ID, which should be the same as the last
part of the inverter ID that appears on the inverter. You may refer to
the Identifying the Inverter section on page 21 for more details.

The next three numbers represent the firmware versions of various
processors.
SolarEdge Installation Guide – MAN-01-00057-2.0
: 0 0 0 0 0 0 0 F
V e r :
V e r :
V e r :
Inverter User Interface
1 . 8 8
0 . 8 1
1 . 4 7 2 7
72