Configuring The Inverter Using The Lcd Panel And User Buttons - SolarEdge SE3000 Installation Manual

Configuring the Inverter Using the
LCD Panel and User Buttons
After installation of the inverter, a field technician can verify and perform basic
configurations of the inverter. This section describes the various LCD messages
and possible configurations using the user buttons.
NOTE:
This process can also be performed using the SolarEdge configuration tool by
connecting a PC or laptop to the inverter via its RS232/USB management port. This
tool is described in the SolarEdge Configuration Tool User Guide.
►
To configure the inverter:
1
Verify that the inverter's ON/OFF switch is OFF.
2
Press the LCD Light button once to turn ON the backlight.
WARNING!
If configuration actions are perfomred after the system has been working,, the
following message is displayed:
This message is displayed until the DC is safe.
The default safety voltage is 50 V.
Do not open the cover or open DC conectocrs until the voltage is indicated as
safe or until at least five minutes have passed.
3
The following configuration procedures are performed with the inverter
cover open. Open the cover, as described in the Opening the Cover section on
page 27.
NOTE:
There are two options for configuring the inverter. One is performed by pressing
the external LCD button, which provides access to the most commonly used
options. If you only want to perform pairing, you can do so without opening the
inverter cover, as described in the LCD Button Menu Options section on page 74.
SolarEdge Installation Guide – MAN-01-00057-2.0
Inverter User Interface
67