SolarEdge SE3000 Installation Manual page 52

SolarEdge Installation Guide – MAN-01-00057-2.0
If the inverter has block terminal communication connectors, then connect as
follows:

The Ethernet block terminal is already inserted into the inverter when it
is delivered. Pull out the Ethernet block terminal, as shown on the left
below:
Figure 25: Removing the Ethernet Block Terminal

Loosen the screws of connectors 1, 2, 3, 6 and S on the Ethernet block
terminal, as shown below:
G
Figure 26: Ethernet Block Terminal
NOTE:
Wires 1-7 may be connected. Only 1, 2, 3, 6 and S are mandatory.
3
7
6
S
Connect Only These
Setting Up Communication
Screws
1
4
2
52