SolarEdge SE3000 Installation Manual page 51

5
An inverter has either RJ45/RJ11 connectors or block terminal connectors for
communication.
If the inverter has RJ45/RJ11 communication connectors, then connect as
follows:

Insert the 4 wires into the RJ45 connector. Make sure to use pins 1, 2, 3
and 6.
Figure 24: Inserting Wires into the RJ45 Connector

Use the Ethernet crimper to crimp the wires.

Connect the Ethernet connector to the RJ45 plug on the board in the
inverter, as shown in Figure 19.
SolarEdge Installation Guide – MAN-01-00057-2.0
Setting Up Communication
51