Creating An Ethernet (Lan) Connection - SolarEdge SE3000 Installation Manual

Creating an Ethernet (LAN)
Connection
This communication option enables you to use an Ethernet connection to connect
the inverter to a LAN.
SolarEdge Inverter
ZigBee RS485 RS232 Ethernet
Router/Hub
Single Inverter Connected
Figure 22: Example of Ethernet Connection
►
To connect the Ethernet communication to the
SolarEdge Monitoring server:
1
Open the cover of the inverter, as described in the Opening the Cover section
on page 27.
2
Using the user buttons, choose the LAN option under the Communication
 Server menu , as described in the Configuring the Inverter Using the
LCD Panel and User Buttons section on page 67.
3
Configure the LAN options under the Communication menu (DHCP and IP
configurations), as described in the Configuring the Inverter Using the LCD
Panel and User Buttons section on page 67.
4
Prepare to connect the Ethernet cable to the Ethernet connector on board in
the inverter, as follows:

Insert the Ethernet wire via the large cable gland on the bottom of the
inverter. The inverter glands come pre-sealed from the factory.
Removing the sealing is needed to insert the cable.
SolarEdge Installation Guide – MAN-01-00057-2.0
SolarEdge Inverter
ZigBee RS485 RS232 Ethernet
Setting Up Communication
SolarEdge Inverter
ZigBee RS485 RS232 Ethernet
Router/Hub
Multiple Inverters Connected
49
SolarEdge Inverter
ZigBee RS485 RS232 Ethernet