Providing Installation Information - SolarEdge SE3000 Installation Manual

IMPORTANT NOTE:
Even if you do not report the physical and logical mapping of the installed power
optimizers to SolarEdge, the SolarEdge Monitoring Portal will still show the logical
layout indicating which power optimizers are connected to which inverters. However, it
will not show strings or the physical location of power optimizers.
This process prepares the SolarEdge Monitoring Portal for receiving
up-to-date information from the installation site and for displaying it in a physical
or logical view.
The inverter may be connected to the SolarEdge Monitoring Server via a LAN or
an external SolarEdge GSM modem connected to the RS232 port. Alternatively,
you can connect the inverter to another inverter that is already connected to the
server.
The inverter-to-inverter connection is made by an RS485 bus or a ZigBee modem.
This connection enables the inverters to send the latest data collected from the
power optimizers and inverters to the SolarEdge Monitoring Server.
If the inverter is properly connected to the internet, as described in the Step 3,
Verifying Proper Operation section on page 37, then the S_OK appears in the
inverter's LCD screen.

Providing Installation Information

IMPORTANT NOTE:
Be sure to record power optimizer serial numbers during their installation, as this
information may be required later for troubleshooting.
iPhone Site Mapper
SolarEdge provides an iPhone Site Mapper that helps you collect information
about your installation. This application leads you through the process of
scanning the labels on each inverter and power optimizer. It then helps you
transmit this collected information to SolarEdge's Monitoring Portal (which was
described on the previous pages). The SolarEdge iPhone Mapping Application
can be downloaded from the SolarEdge website.
SolarEdge Installation Guide – MAN-01-00057-2.0
Commissioning the Installation
39