Connecting The Inverter To The Solaredge Monitoring Server - SolarEdge SE3000 Installation Manual


RS232 or USB Connector:

Provides a configuration, control and management connection to a
locally connected PC or laptop, or to an external modem (RS232 only)
for connection to the SolarEdge Monitoring Portal. You may refer to the
Creating an RS232 (UART) Connection section on page 47 for a
description of how to set up this communication option to the SolarEdge
Monitoring server.
You may refer to the SolarEdge Monitoring Portal User Guide for more
information about the monitoring capacities.

Other Communication Options (Ethernet (LAN) or ZigBee): Two other
types of communication options can be used to connect the inverter to the
SolarEdge Monitoring Portal. They are installed through the three cable
glands. You may refer to the Chapter 6, Setting Up Communication on page
45 for a description of how to set up these communication options to the
SolarEdge Monitoring server.

AC Output:
AC Cable External Gauge: M25 (11-17mm diameter).
Each of the AC wires (Line, Neutral and PE) must be a copper wire with a
cross-section of 4-16 mm

DC Cable: PV connectors.
Connecting the Inverter
Opening the Cover
►
To connect AC wires to internal inverter terminals:
1
Turn OFF the AC on the AC wires to be connected to the inverter by
disconnecting the circuit breakers on the main circuit board.
2
Turn off the ON/OFF switch at the bottom of the inverter.
3
Turn off the DC switch on the main circuit board, if one exists.
4
If the inverter was on prior to disconnecting the switch, then wait at least five
minutes before opening the cover of the inverter.
WARNING!
Do not open the cover of the inverter before you turn OFF the ON/OFF switch at
the bottom of the inverter and the DC switch of the main circuit board.
5
Unscrew the Allen screws on the cover of the chassis (on its front) and lift
the cover up.
SolarEdge Installation Guide – MAN-01-00057-2.0
2
.
Installing the Inverter
27