SolarEdge SE3000 Installation Manual page 24

3
Hang the inverter on the bracket using the screws on the inverter's top, as
shown below:
Figure 8: Hanging the Inverter on the Bracket
CAUTION:
Do not rest the connectors at the bottom of the inverter on the ground at any time, as it
may damage them. If you need to rest the chassis on the ground, lay it on its back,
front or side, not on its bottom.
4
Let the chassis lay flat against the wall or pole. Then, screw the two Allen
screws into the right and left sides of the bottom of the bracket. The screws
go through the heat sink on either side into the bracket, as shown below:
Figure 9: Inserting the Screws through the Bottom of the Heat Sink
SolarEdge Installation Guide – MAN-01-00057-2.0
Installing the Inverter
24