Confirming Or Selecting The Test Strip Lot - Accu-Chek INFORM II Operator's Manual

Confirming or selecting the test
strip lot
Patient Test 12:48
Patient 123456789
Use Strip Lot 545794 ?
11/19/12
Strip Lots 12:48
545794 545794
344789
545777
344654
11/19/12
Once you have entered and confirmed the patient ID, you
are asked to choose the lot number for the test strips.
Compare the number displayed by the meter to the
number on the label of the test strip vial.
1 Select the lot number as follows:
pm
If you want to use the preselected lot number dis-
■
played by the meter, touch
To use a different lot number than the one dis-
■
played, touch
numbers. Select the desired lot number from the
list.
To read the lot number from the test strip vial via
■
barcode scanner, press and release
the instructions for scanning IDs (see note below).
2 Touch
pm number.
The meter can be configured so that manual
confirmation is not necessary. In this setup, only the
lot number is displayed. Additional options are not
available.
The meter can be configured so that lot numbers are
entered via barcode scanner only (see note below).
For additional information about storing lot numbers for
test strips, see page 67.
Note: Barcodes on test strips vials/control solutions
may not be available in all countries. In this case either
manually enter the lot number each time
■
(recommended),
pick a previously entered lot number from the list,
■
or
configure the meter to only display the lot number
■
(without confirmation by the operator).
Patient Glucose Testing • 3
to confirm.
to display a list of stored lot
to confirm the selected or scanned lot
. Follow
45