A Appendix; Table Of Configuration Options - Accu-Chek INFORM II Operator's Manual

A Appendix
A.1

Table of configuration options

Configuration options
Subject/Attribute
Timer
Shutdown timeout (meter powers off if no
activity)
Display: Low Power Mode after
[0 = feature disabled)
Beeper
Beeper volume
Measurement Flow
Comments required
Comments requirement level: if out of...
(only valid if Comments required = 1)
This section provides an overview of all the settings
available.
The two rightmost columns describe the accessibility of a
configuration parameter on the device (Setup Menu) and
via the data management system (DMS).
"Y" (Yes) means, that this parameter is available, "N" (No)
means, that this parameter is not available using the
respective configuration method.
DEVICE: If the meter is configured by a system admin-
istrator using a data management system, the config-
uration options on the meter may be disabled to avoid
conflicts in the settings. This option is indicated by the
use of parentheses e.g., (Y).
DMS: Configuration options may vary depending on
available DMS settings.
Range
30 – 3,600 s
0 – 120 s
0: low
1: medium
2: high
0: optional
1: out of range
2: required
3: disabled
0: normal range
1: critical range
2: reportable range
3: measurement range
Appendix • A
Default Device
300 N
30 Y
2 Y
0 N
0 N
DMS
Y
Y
Y
Y
Y
149